MACHINES AND MECHANISMS

Mathematical modeling of the performance characteristics of a two-stage centrifugal pump 1.5K-6 at variable rotational speed

Authors

How to cite

GOST Malazi S. A., Ziborov D. M., Davydov A. M., Doronina O. S. Mathematical modeling of the performance characteristics of a two-stage centrifugal pump 1.5K-6 at variable rotational speed // STROITEL'NYE I DOROZHNYE MASHINY. 2026. Vol. 70. No. 10. P. 73-82. DOI: 10.25726/k4781-2286-9670-m
APA Malazi, S. A., Ziborov, D. M., Davydov, A. M. & Doronina, O. S. (2026). Mathematical modeling of the performance characteristics of a two-stage centrifugal pump 1.5K-6 at variable rotational speed. STROITEL'NYE I DOROZHNYE MASHINY, 70(10), 73-82. https://doi.org/10.25726/k4781-2286-9670-m

Abstract

The results of experimental determination of the performance characteristics of a two-stage centrifugal pump 1.5K-6 in the rotational speed range of 1500-3000 rpm are presented. The measurements were carried out on a laboratory test rig with speed control of a DC electric motor; the flow rate was determined as the mean of the rotameter readings and the volumetric tank data, and the head was determined from the pressure gauge and vacuum gauge readings. A mathematical model has been developed based on the Euler equation with the Stodola–Pfleiderer correction and taking into account hydraulic, disk friction, and volumetric losses. The model parameters were identified from experimental data at the nominal rotational speed of 2000 rpm using the least squares method; the coefficient of determination was 0.994 for head and 0.987 for efficiency. The maximum pump efficiency of 0.59 was achieved at a flow rate of 0.0021 m³/s. Verification of the model showed that in the flow-rate range of 0.4-1.2 of the optimal value, the average relative error is 4.6% for head and 5.8% for efficiency. At low flow rates, the error increases to 10-12% due to recirculation flows that are not taken into account by the one-dimensional model, while at high flow rates the influence of cavitation becomes noticeable. The affinity laws are satisfied with an error of 5-7%, which confirms the suitability of the model for engineering recalculation of pump characteristics when the rotational speed changes.

Keywords

centrifugal pump mathematical modeling Euler equation slip factor similarity laws experimental verification

Funding

The authors did not declare any external funding for this research.

References

Lomakin A.A. Centrifugal and axial pumps. 2nd ed., revised and enlarged. Moscow; Leningrad: Mashinostroenie, Leningrad Branch, 1966. 364 pp.

Hydraulic machines // Proceedings of the Moscow Power Engineering Institute. Issue 132. Under the general editorship of V.S. Kvyatkovsky. Moscow, 1972. 162 pp.

Stepanov A.I. Centrifugal and axial pumps. Theory, design and application. Translated from English. Edited by V.I. Polikovsky. Moscow: Mashgiz, 1960. 463 pp.

Shevchenko N.G., Shudrik A.L. Numerical modeling of viscous fluid flow in the stage of a submersible centrifugal pump // Bulletin of the National Technical University "KhPI". Series: Hydraulic Machines and Hydraulic Units. 2015. no. 3 (1112). pp. 59-67.

Abuchar-Curi A.M., Coronado-Hernández O.E., Useche J., Abuchar-Soto V.J., Palencia-Díaz A., Paternina-Verona D.A., Ramos H.M. Improving pump characteristics through double curvature impellers: experimental measurements and 3D CFD analysis // Fluids. 2023. Vol. 8. no. 8. Art. 217.

Baloni B.D., Shah M.T., Channiwala S.A. Experimental study on performance of centrifugal pump. // International Conference Fluid Power 2025: Conference Proceedings Eds. D. Lovrec, V. Tič. Maribor: University of Maribor Press, 2025.

Capurso T., Stefanizzi M., Pascazio G., Ranaldo S., Camporeale S.M., Fortunato B., Torresi M. Slip factor correction in 1-D performance prediction model for PaTs // Water. 2019. Vol. 11. no. 3. Art. 565.

Chen K., Zhang F., Liu R., Adu-Pokua K.A., Yuan S., Hong Q. Experimental and numerical evaluation of affinity law of single-stage and multistage side channel pumps at variable rotating speeds // ASME. Journal of Fluids Engineering. 2023. Vol. 145. no. 10. Art. 101201.

Gülich J.F. Disk friction losses of closed turbomachine impellers // Forschung im Ingenieurwesen. 2003. Vol. 68. pp. 87-95.

Gülich J.F. Centrifugal pumps. 4th ed. Cham: Springer, 2020. xlviii, 1264 p.

Hailu G., Varchola M., Hlbocan P. Centrifugal and mixed-flow pumps // Design of Hydrodynamic Machines. Taylor and Francis, 2022.

KAMAT GmbH and Co. KG. Overall efficiency explained simply // Pump Efficiency. 2025.

Moffat R.J. Contributions to the theory of single-sample uncertainty analysis // ASME. Journal of Fluids Engineering. 1982. Vol. 104. pp. 250-260.

Montazerin N., Akbari G., Mahmoodi M. Volute // Developments in Turbomachinery Flow: Forward Curved Centrifugal Fans. Cambridge: Woodhead Publishing, 2015. pp. 59-83.

Pedersen N., Larsen P.S., Jacobsen C.B. Flow in a centrifugal pump impeller at design and off-design conditions. Part I: Particle Image Velocimetry (PIV) and Laser Doppler Velocimetry (LDV) measurements // ASME. Journal of Fluids Engineering. 2003. Vol. 125. no. 1. pp. 61-72.

Pfleiderer C. Die Kreiselpumpen für flüssigkeiten und gase. Berlin: Springer, 1961. 622 p.

Ramos H., Borga A. Pump as turbine: an unconventional solution to energy production // Urban Water. 1999. Vol. 1. pp. xii, 622

Semenzin C.S., Mapley M., Wu E., Pauls J.P., Simpson B., Gregory S.D., Tansley G. Open-source automated centrifugal pump test rig // HardwareX. 2020. Vol. 8. Art. e00140.

Derakhshan S., Nourbakhsh A. Experimental study of characteristic curves of centrifugal pumps working as turbines in different specific speeds // Experimental Thermal and Fluid Science. 2008. Vol. 32. no. 3. pp. 800-807.

Stepanoff A.J., Stahl H.A. Dissimilarity laws in centrifugal pumps and blowers // Journal of Engineering for Power. 1961. Vol. 83. no. 4. pp. 381-390.

Issue

Section

MACHINES AND MECHANISMS

Metrics

13 views
0 downloads
Want to publish with us?
Submit an article

Similar Articles

<< < 1 2 3 4 5 > >> 

You may also start an advanced similarity search for this article.